Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Bow Eye Repair
I have a 73 Starcraft fiberglass boat on which the bow eye was beginning to
pull through. Upon further inspection I found that the wood on the inside of the hull had disintegrated. I removed the fiberglass covering where the wood used to be and removed all the wood particles. There is no more wood in the area. I intended to repair it by making a new piece of wood approximately the same dimensions as the old one then fiberglassing over it before attaching the bow eye. Do I need to put fiberglass resin, epoxy or sealant between the new wood and the inside of the hull? Should I fiberglass over the new wood before bolting the eye on or after? Any other suggestions? Thanks Mike |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
The Bush Economy Stinks...and Sinks | General | |||
marine engine repair schools? | General | |||
To replace or repair... | General | |||
spark plug damage repair | General | |||
malibu response question | General |