On Fri, 5 Oct 2012 15:06:24 -0700 (PDT), Tim
wrote:

On Oct 4, 9:44*pm, Wayne B wrote:
On Thu, 04 Oct 2012 22:20:32 -0400, wrote:
I would get a pack of phasing tape at HD (usually at least 5-6 colors)
and re identify all of those wires to standard black, white and green

===

I've been doing that on an "as needed" basis when I'm into a circuit
for some reason. *The issue is actually even worse than I described
since only the "hot" wire of each circuit goes to the breaker panel.
Neutral and safety ground go to bus bars in a special panel located
elsewhere. *Everything is loose wire in harnesses of course, in the
same lovely shade of red.

You mean, they don't wire to any kind of 'standard?"

===

Of course they do. It's the Asian AWAR standard (All Wires Are Red).

:-)



?8^ 0