About Us

[email protected]

On Wed, 10 Aug 2011 15:46:35 -0400, BeachBum "not a
wrote:

On 8/10/2011 3:32 PM, wrote:
On Wed, 10 Aug 2011 11:52:01 -0700 (PDT), jamesgangnc
wrote:

On Aug 10, 1:34 pm, wrote:
"jamesgangnc" wrote in message

All the ones I have pulled apart that shaft goes through a seal into
the area where there is gear lube. But that's on i/o's. Maybe it's
different on outboards.

I have had outboards be a little cranky but never had to pry one
apart.
Start the nuts a few turns so it won't drop and kick the gear housing
"bullet" on each side. That will rock it and break it loose most of
the time
If it was one of the shafts corroded up you would still have a little
free play. My bet is still the locating pins.

The bolts, if stainless, cause a reaction with the aluminum housing. the
resulting white oxidation wedged tightly in the gap causes the binding.
Grease or never seize will prevent the problem in the future. Wedging
the halves apart is the best solution in stubborn cases

I can see daylight between the upper and lower now, at last toward the
prop end. I don't think the corrosion where the halves come to gether
so much as in the threaded studs or where the shaft goes into the top
end.

I've been using a chisel at the narrow end, above the prop. That's
where I can see through to the other side. At the risk of gouging the
other end, toward the stern, I may have to gouge it up a bit.

The anti-corrosion spray can only do so much if the shaft is corroded
into the gearing up top. (I don't know the technical jargon).

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Paint/corrosion issue on 2004 Volvo Penta outboard unit	[email protected]	General	7	June 2nd 07 02:10 PM
25 hp outboard engine disassembly of lower unit	[email protected]	General	3	November 10th 06 04:47 AM
1979 Johnson 100 HP water jetting out from upper/lower unit joint	GreenandGoldonMySleeves	General	0	August 28th 06 06:33 AM
Problems with outboard lower unit if you see....what???	Doug Kanter	General	2	October 4th 04 05:28 PM
Merc 7.5 outboard: I canna get the lower unit off,..	ROBMURR	General	2	September 7th 03 12:39 AM

Menu

About Us