On 3/25/2011 7:52 AM, OmDeFlume wrote:
On 3/24/2011 11:25 PM, Lil Abner wrote:
On 3/24/2011 8:57 PM, Frogwatch wrote:
Got my fully tinned wire for my trailer and put it on so now I have
trailer lights again. However while doing it, I found that all of the
bolts and nuts on the trailer are so badly corroded they will not last
another season. I probably need about $100 of stainless hardware to
replace them. I thought EZ Loader was quality but it isn't. What
would a bit of stainless or hot dipped galv bolts have cost them?
What about sacraficial anodes? They come in many sizes and shapes.
Of course you will still have to replace the rusted hdw now.
I don't know that it would work but seems like it should.

Zincs need to be submerged in water to become an anode.
I'm not sure of the science behind it. If moisture, in the air, and
natural electricity was making it to ground it would rust or a
sacrificial anode could take it's place? You would think rubber tires
would insulate it sufficiently but perhaps the jack stand is the route?
If none of this makes sense oh well.