"HarryK" wrote in message ...
On 12/13/10 11:49 AM, YukonBound wrote:


"Ziggy®" wrote in message
...
"YukonBound" wrote in message
...


"I am Tosk" wrote in message
...
In article ,
says...

In article ,
says...

"I am Tosk" wrote in message
...
In article ,
says...

On Sun, 12 Dec 2010 11:02:22 -0500, John H
wrote:

It wouldn't be that different from launching the present dinghy
except
for the reassembly. The small section would go in first with
the
bow
painter on it, then tie it off on the stern of the big boat.
Next
you'd launch the big section with a stern line on it. Next
step
would be to get into the big section, line it up with the small
one
and bolt them together. It would be difficult in windy weather
but we
try to avoid that even now.

The important thing is to take lots of pictures and share
them with
us!

You know I'd do that.

I'm beginning to have my doubts about the feasability of the
"stretch"
modification however. Some good points have been raised about
the
stresses at the attachment point joining the two halves. Growing
the
boat larger would only make that worse, especially with an
outboard
big enough to reach planing speeds.

The design was intended as a small rowing and sailing dinghy and
that
is probably where it should stay.

I'm thinking that one of Scott's Brockway Skiffs could
probably be
built as a two piece boat that would be more suitable for a big
outboard if the right attachment method could be found. It
would be
heavy though unless built with high tech materials.

http://www.yaimkool.com/

http://photobucket.com/images/brockway%20skiff/

You know.. A one piece 12 foot version of that boat can be built
under
200 pounds or at least close. A 12 footer can carry 4 folks
comfortably
with probably 6-800 pounds of gear and supplies. An 8 horse engine
will
make the thing fly too...

-- Rowdy Mouse Racing - Pain is temporary, Glory is forever!

Must be a magic boat.
My 14.5 foot aluminum boat is rated for just under 900 lbs......
that is
three adults and gear here in Canada.

27 mph is "flying" in your neck of the woods?

Don't mind the trolls. I have been in Don's rowboat, it's about 3 feet
wide with a round bilge and stem..... Ever hear the term, "Apples and
Oranges"?


Is that so?
Maybe Tom will act as the voice of truth here.
I say it's about 67" wide with a nice wide transom.... I have, and can
again, provide pictures.
You've been outted as a bald faced liar Scotty........ no surprise
there!
http://www.princecraft.com/Content/e.../Yukon-15.aspx


How do you drive that thing? There's no steering wheel.

--
Ziggy®

The way real sailors "drive boats"..... with a tiller (handle tiller in
this case)


Ziggy, like BAR, is boatless and probably tiller-less, too.


I'll thank you to keep your stubby hands off my tiller.

--
Ziggy®