About Us

Don Won

In article ,
says...

"I am Tosk" wrote in message
...
In article ,
says...

In article ,
says...

"I am Tosk" wrote in message
...
In article ,
says...

On Sun, 12 Dec 2010 11:02:22 -0500, John H
wrote:

It wouldn't be that different from launching the present dinghy
except
for the reassembly. The small section would go in first with the
bow
painter on it, then tie it off on the stern of the big boat.
Next
you'd launch the big section with a stern line on it. Next step
would be to get into the big section, line it up with the small
one
and bolt them together. It would be difficult in windy weather
but we
try to avoid that even now.

The important thing is to take lots of pictures and share them with
us!

You know I'd do that.

I'm beginning to have my doubts about the feasability of the
"stretch"
modification however. Some good points have been raised about the
stresses at the attachment point joining the two halves. Growing
the
boat larger would only make that worse, especially with an outboard
big enough to reach planing speeds.

The design was intended as a small rowing and sailing dinghy and
that
is probably where it should stay.

I'm thinking that one of Scott's Brockway Skiffs could probably be
built as a two piece boat that would be more suitable for a big
outboard if the right attachment method could be found. It would be

Nice insulting and name calling. That should help with the group
harmony.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Boat building vs camper building	Frogwatch[_2_]	General	35	February 11th 09 01:28 AM
Boat kit (folbot) in western NC	TB	General	2	December 2nd 04 01:36 AM
Antique boat kit still in boxes	TOLYN10	Boat Building	2	August 27th 04 07:39 AM
Easy kayak building kit	Pagaie	Boat Building	11	May 20th 04 01:10 PM
pirogue boat kit	Brian Blazer	Boat Building	17	November 26th 03 06:22 PM

Menu

About Us