Home |
Search |
Today's Posts |
#15
![]()
posted to rec.boats
|
|||
|
|||
![]()
On Mar 30, 10:52*am, Harry wrote:
On 3/30/10 10:10 AM, Tim wrote: There's an old saying at a local high performance engine shop that says "Speed costs money, how fast do you want to go?" And I know the old rule usually applies "you get what you pay for? Well for the few times I've taken my marquis out it's interesting to get it up on plane. first , if you ease the throttle, you'll do a wheelie to where you think the boat will flip over backwards and you do little but plow water , so you have to nail it and you still get an extreme bow rise but it settles down and know you're going, but you still have to keep the RPM up above 2800 or the boat wants to drag back. So I'm investigating trim tabs. There's all kinds on the market anywhere from sophisticated hydraulic and independently controlled units ranging up to around $500.00 all the way down to the spring loaded sets that that are available for around a hundred bucks. I'm sure that trim tabs would help the boating experience, but *I'm really wondering how much trim control I'm actually needing. to make a more efficient ride and run. I'm constantly accused of being 'tight' but I'm not THAT tight, because I know that money spent in the right direction will save in fuel and ride in the longer run. But over kill is still overkill. This is a 23 ft. V-hull Marquis with a 350 GM engine and not some 3000 hp. 40 ft. Fountain off shore racer. So, anyone have any suggestions? A properly installed set of tabs will do the job for you. Question...are you running the prop specified by the manufacturer for that rig? There are props that on a given boat will produce more bow rise than other props. You might have a bad mismatch. I am totally unfamiliar with outdrives. Does yours have enough trim so that you can pull the lower unit in closer to the bottom of the transom? BTW, one problem buyers of aftermarket tabs often face...is buying a set of tabs too small for the job. I didnt see where he said it was an Outdrive. I also would NOT put a Whale Tail on it. IMO...it stresses the transom more. If this an outdrive Boat. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
trim tabs | General | |||
Trim tabs size question | General | |||
Trim Tabs | General | |||
Trim tabs | General | |||
trim tabs | General |