Looking for a 1" x 14 fine thread nylon/plastic nut to use on the layover
marine antenna mount post.

I've found a bunch of online sources for nylon and plastic nuts, but they
don't quite make it to 1"x 14. Close, but not right on.

If anyone knows where I can buy two or three of these, I'd appreciate
hearing from you on it.

Try McMaster Carr: http://mcmaster.com If it is hardware and it is for sale, they should have it.

Doug

McMaster Carr is a good suggestion. If you run into a dead end there
I'd suggest contacting a plastic distributor. Not a molder, but
somewhere that carries rod & sheet stock. They can fabricate a nut for
you pretty inexpensively. Either cut out of nylon plate stock, or
sliced off nylon rod stock. The drilling and threading wouldn't be a
big deal if a person had the right size tap.

This thread is used by the major antennae manufacturers.
Try them or antennae suppliers.

Alec


"RB" wrote in message
...
Looking for a 1" x 14 fine thread nylon/plastic nut to use on the layover
marine antenna mount post.

I've found a bunch of online sources for nylon and plastic nuts, but they
don't quite make it to 1"x 14. Close, but not right on.

If anyone knows where I can buy two or three of these, I'd appreciate
hearing from you on it.

Looking for a 1" x 14 fine thread nylon/plastic nut to use on the layover
marine antenna mount post.

You might try McMaster-Carr at:
http://www.mcmaster.com/

HTH

Vic

--
__________________________________________________ ______

Victor Fraenckel - The Windman
victorf ATSIGN windreader DOTcom
KC2GUI

If McMaster doesn't have them, try: http://www.smallparts.com/