LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #12   Report Post  
Jay
 
Posts: n/a
Default

Sorry, that was a bit uninformative..
They weigh about 2 or 3 pounds/piece. They didn't come with back braces,
and they would probably mount ok... my concern is the shock of slamming over
wakes over time, cracking the perimeter...

"Features: * Rubber surround * Magnetically Shielded * Weather-resistant
woofer * UV impregnated ABS heat-resistant weatherproof grilles * One-piece
formed ABS basket* Recommended amplifier power 10-60 watts RMS, 150 watts
Peak * Requires 3.45" of mounting depth and 5.63" cutout diameter * * Dual
Cone: Mylar * Cone: Polypropylene * Basket: Durable and light weight ABS
plastic"


"JimH" wrote in message
...

"Jay" wrote in message
...
Well, these ( http://tinyurl.com/692pp ) are the ones I got.

They'll be going on either side of the walkway to the open bow (at cruise
the two rears can't be heard at all, really.) I can climb under the dash
on either side with enough room to work, and water (though moisture
might) doesn't usually find it's way into that area..

-j

wrote in message
...
On Sun, 20 Feb 2005 17:03:14 -0500, "Jay" wrote:

So I finally found a set of speakers that seemed like a good enough deal
and
they came in last week. I'm wondering if anyone has any
input/experience
installing speakers. They aren't flush mount which needs I'll need to
be
cutting a few holes... some of my curiosity lies in wondering if there's
any
certain saw blades one should use for cutting fiberglass.... I was going
to
just drill a few holes to start a hand jig saw... maybe tape up the area
with duck tape to avoid scratching.. other than that I didn't really
know if
there was anything one should take precaution with.

Also, though they weigh a couple pounds each, should I worry much about
providing some of support to the backing... like a brace to dissipate
weight
on the fiberglass walls?

TIA

-j


Where on the boat are you installing them? Most speakers I've seen are
inappropriate for use in the cockpit, if that is what you are planning.
Unless
they have a sturdy and solid enclosure, they are strictly for inside the
cabin,
or maybe up high in a flying bridge. Speakers without enclosures in the
cockpit,
instantly become large holes for water to enter if the boat gets pooped.

BB





The link tells us nothing about the speakers other than that they *are*
flush mount.

No backing plate needed.

If they are exposed to the sun and sea spray I hope they are capable of
withstanding the long term effects...rubber surrounds and neoprene cones.

If not be prepared to be replacing them every year or two.

Sometimes cheap is not always the best deal.



 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
SSB Installation Jerry Peters Cruising 2 February 9th 05 04:01 PM
Trysail Track Installation JAWs Cruising 11 May 28th 04 03:24 PM
FS: Marine PA Speaker in NY Bobsprit Marketplace 0 March 31st 04 03:26 PM
vhf ext speaker mike hicks General 3 September 6th 03 03:30 PM


All times are GMT +1. The time now is 03:53 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 BoatBanter.com.
The comments are property of their posters.
 

About Us

"It's about Boats"

 

Copyright © 2017