Home |
Search |
Today's Posts |
#26
![]() |
|||
|
|||
![]()
Be careful about running copper. It is subject to fatigue due to
vibration. Our surveyor made us remove all of it and replace it with approved rubber hose. Doug s/v Callista "rhys" wrote in message ... On Fri, 10 Dec 2004 17:46:35 -0500, Rodney Myrvaagnes wrote: It was the converted Kenyon with 10,000-BTU burners that caught my eye. But your last leaves me puzzled. I don't know what the galley stove does if you do your cooking outsied. It does nothing at the moment because I still have to run the copper, do the flanges and figure out where I want to put the hole to the outside. The rest is done, and as the sensor system is active (it sure notices spilled gasoline...) and all the parts are on board, it's just a matter of getting it done. So I suppose were I a person who liked to push his luck, I could run the camp stove in the galley, because the sensor would whine if I leaked propane into the bilge...but I prefer the fresh air of the cockpit anyway. If I drop something, I can rinse it down the drains G Lot of illness and work took time out of my life's vocation of boat repair and resurrection this year...alas. That's why it's so planned out and yet so not done. R. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
alcohol vs gas stoves | Boat Building | |||
trident propane sensors | Boat Building | |||
trident propane sensors | Electronics | |||
Copper Tubing in Propane System | Cruising | |||
Alchohol stoves | General |