I'm about to start the construction of a Robert 434 in aluminum next summer.
I have experience in aluminum welding but boatbuilding is a different
subject that just doing butt join. I'm wondering if someone on the group
has some experience in doing the final welding of an aluminum boat and if
there is a book where i could find such knowledge.

I currently have a lot of books on steel boat construction (Colvin, Klingel
and others) and i have ordered Boatbuilding with Aluminum from Stephen F.
Pollard. Any other would be helpful.

Altough i know how to do X-ray quality weld from 1/8 to 1/2 in 5034 alu,
what stresses me the most is the specific welding techniques to remove
stress point in the hull and so on.

Thanks !

I am building a much smaller (20') Billy Atkin design - I do the cutting and
fitting, hiring a welder to do the seams. On this scale, there seem to be
few issues with the detailing.

Only two books I have seen on Alum boatbuilding:

Pollard, you ordered Boatbuilding with Aluminum ISBN: 0070504261
Sims Aluminum Boatbuilding ISBN: 1574091131

Also Gerr: The Elements of Boat Strength ISBN: 0070231591

Check out the Metal Boat Society forum http://metalboatsociety.org/ for
intelligent discussion of issues.

--

"André Langevin" wrote in message
...
I'm about to start the construction of a Robert 434 in aluminum next
summer. I have experience in aluminum welding but boatbuilding is a
different subject that just doing butt join. I'm wondering if someone on
the group has some experience in doing the final welding of an aluminum
boat and if there is a book where i could find such knowledge.

I currently have a lot of books on steel boat construction (Colvin,
Klingel and others) and i have ordered Boatbuilding with Aluminum from
Stephen F. Pollard. Any other would be helpful.

Altough i know how to do X-ray quality weld from 1/8 to 1/2 in 5034 alu,
what stresses me the most is the specific welding techniques to remove
stress point in the hull and so on.

Thanks !

Boatbuilding with aluminum by Stephen F. Pollard
regards
Perry
www.custom-aluminum-boats.com

"André Langevin" wrote in message
...
I'm about to start the construction of a Robert 434 in aluminum next
summer. I have experience in aluminum welding but boatbuilding is a
different subject that just doing butt join. I'm wondering if someone on
the group has some experience in doing the final welding of an aluminum
boat and if there is a book where i could find such knowledge.

I currently have a lot of books on steel boat construction (Colvin,
Klingel and others) and i have ordered Boatbuilding with Aluminum from
Stephen F. Pollard. Any other would be helpful.

Altough i know how to do X-ray quality weld from 1/8 to 1/2 in 5034 alu,
what stresses me the most is the specific welding techniques to remove
stress point in the hull and so on.

Thanks !