zero clearance cutting tools?

Robert Larder

Posts: n/a

zero clearance cutting tools?

Never tried it, but how about a Fein Multimaster with a cranked saw blade?

Evan Gatehouse wrote:
I am going to trim some plywood frames that intersect the hull right
at the shoulder position of a few quarterberths. These are either
1/4" or 3/8" plywood frames, tabbed both sides to the hull. By the
way, I'm a naval architect and mech. engineer so I have a pretty good

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is Off HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
where to buy volvo tools?	Black-n-Gold	General	3	July 8th 04 07:19 PM
opinions sought for full-time cruiser Tools and Spares selection	Skip Gundlach	Boat Building	32	February 9th 04 10:56 PM
Cutting fibreglass	Lloyd Sumpter	Boat Building	8	January 4th 04 04:43 PM
Cutting Fiberglass-Rotary Cutter	Derek Hartmann	Boat Building	1	January 2nd 04 10:13 PM
The best knife for cutting fish into bait...	Harry Krause	General	15	December 27th 03 03:59 PM

All times are GMT +1. The time now is 02:09 PM.

Menu

About Us