| Home |
| Search |
| Today's Posts |
|
|
|
#1
|
|||
|
|||
|
Walt wrote in message ...
Im thinking about putting a small 3.5 hp 2 stroke outboard on the square tansom of a 16 foot long canoe. My intention is to extend my paddling exploring range by using the outboard motor to go the three to five miles to where I want to paddle. At times, the canoe may have 2 adults and 2 kids. Im expecting that this arrangement will cruise along at maybe 5 mph and that going to higher horse power (say 5 hp) wont really buy me much in speed. I also like the weight of the 3.5 hp 2 stroke outboard at 35 pounds which makes it very portable. Ive never used this arrangement before and hopefully can find out beforhand if it will do about what Im expecting. Any coments or experience would be appreciated. Wally Hall Denver I agree with everyone else, get a 2 horse, it will do just fine. Probably, note I said probably go as fast as with a three. Scotty from SmallBoats.com |
|
#2
|
|||
|
|||
|
I agree with everyone else, get a 2 horse, it will do just fine.
Probably, note I said probably go as fast as with a three. Scotty from SmallBoats.com In case you need one, I have some of the Neptune 17lb Mighty Mites that were returned for warranty back in 91. Excellent little motors. Not to be confused with the "weedeater" type: Tanaka, Cruise N Carry etc. throw away motors. Also bought all their new parts. I use one on my canoe all the time (side bracket) I run upstream a ways from put in point and float back down. Saves having to shuttle vehicles & I can go alone. Contact me off group if you need one. Greg Sefton |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Small outboard recomendations | General | |||
| can I convert a long shaft small outboard to short shaft | General | |||
| OT Bush hatred | General | |||
| Need books, articles, website to design a canoe (concrete) | Boat Building | |||