On Sat, 03 Sep 2005 17:14:25 GMT, "Roger Derby"
wrote:


That's it. Another thing to remember about pontoons is that each pontoon
should be able to float close to the maximum load. You want to be able to
walk right over to the edge of the boat carrying bar-b-que and cooler, and
have it remain level.


Roger,
Did the boat emit a sonar sound just before submersing?.....)
I would probably have dropped a letter to that manufacturer and asked
them just how deep the pontoon boat can submerge before it's
considered a diving vessel.....lol. I bet they would not think it was
funny though. Thanks for your replies. I will take what i have learned
from you and Mr. Watt and get some figures put together. Then i'll
post a few numbers along with sizes, and see what everyone thinks.
Thanks again.

regards,

M Russon

This discussion needs to be considered in simplistic terms.

If you build a square section with flat front you will need a lot of
power to push it through the water.

This is why the commercial pontoons are tapered at the front in such
a way as to provide a smooth water flow and reduced resistance.

You can build a pontoon out of plywood by using a parabolic section
base and flat top.
(like a U section)

A thin ply can be bent around the bulkheads and the spaces filled with
flotation foam.

There is another thread on the rec.boats forum concerning attachment
loads for skinned structures. Simply stated you need to spead the
stresses out at attachment points or you rip out the plywood.


There are a number of old boat plans for pontoon boats. Maybe your
library has something.

Correction.

I meant to say this discussion has been stated in somewhat simplistic
terms.

There is a lot about hull shape , directional stability etc to be
considered.

For example, you could build a pontoon boat that will carry tem people
evenly distributed over the boat. If someone shouts ' come look at the
pretty birdy' and all ten rush to the left side rail you have a
situation. The requirement that the boat stay flat in that situation
changes the design.

Weight and balance left/right and front/back need to be considered. (I
suppose I should have said port/starboard and fore/aft but you know
what I meant - and which way is port again ?)