Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
It is also very important to make sure the room you work in does not
get warmer after applying resin. This causes it to bubble. Also you need to work at recommended temperatures. Usually between 60 and 90 degrees. Temperature regulates how thick your resin is as you apply it. Too, cold, too thick and hard to work, too warm, it sets up fast and you don't get much done before you need to refill. I like to stay between 60 and 70 degrees F. Don't try to push too hard when squeezing resin around, just try to get excess. Don't try to go too fast, work the area for a little bit to be sure and let the glass soak up all the resin it can. Also it is easier to apply all glass cloth at once, but not critical. Otherwise you will end up with more sanding, and bad edges because the edge of the dried cloth you go over may stick up and make a rough edge and more work later on cleaning up. I know this sounds scary, but you will be amazed out how easy it is. The only thing you can do wrong is not mix your resin correctly which will make a never drying sticky mess you will have to clean up. Everything else you do wrong can be fixed later. On 13 Apr 2005 08:54:06 -0700, (Pagaie) wrote: I have finished assembling my S&G Pygmy hull (Arctic Tern). I have now to fiberglass it. I have read the manual and also a lots articles and personal building pages on the web, and I am still confused, fearing the fiberglassing step. Some call for painting epoxy prior to fiberglassing, some not. Some use squeegee and bristle brush and others say rollers are the best. So, before doing it I'd like to have a final piece of advice from you readers, the pros and cons of different fiberglassing approach and tools. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Fiberglassing over wood? | Boat Building | |||
Questions about Fiberglassing Wood - OurBoat.jpg (0/1) | Boat Building |