Home |
Search |
Today's Posts |
#11
|
|||
|
|||
Andrew,
Another point to keep in mind is density. The difference between cast lead at around 11+ tons per Cubic Meter and lead shot at 7 tons should persuade you not to use resin and other methods for weights as other materials become more viable at the lower densities. Steve "Andrew Butchart" wrote in message ... I've come into possession of a quantity of lead wheel weights - about 70lbs worth. I'd like to turn them into 10lb weights with an eyebolt on the top. One minor issue is that the weights were stored in an old grease pail and so are quite greasy. As I see it I have three options: - Melt it down and pour it into forms. The good thing with this, is that the weights will be all lead. The bad thing is that I don't know how to make forms - would wood be good enough, or old juice cans? Could I melt the lead on my BBQ - kitchen stove is out because of fumes of course. What about the grease? Should I clean it off first? I'm not keen on this method because of all of the safety issues, but it give me the "best" and most dense result. - Use polyester resin and 1 litre cardboard milk cartons as a form to cast a weight. Would it hold together? Do I need to remove the grease from the wheel weights? - Put the weights into a large juice can and somehow seal up the top. I'd worry about how solid this would be though. Thanks -- Andrew Butchart |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Sea kayak, ballast, use of lead blankets, just an observation | General | |||
Sea kayak, ballast, use of lead blankets, just an observation | Touring | |||
Deep cycle batteries - miscellaneous advice? | Electronics | |||
Adding lead ballast | Boat Building |