Home |
Search |
Today's Posts |
|
#1
posted to rec.boats.building
|
|||
|
|||
Cut and Fold Aluminum
"brian whatcott" wrote in message
... Bob La Londe wrote: /snip/ I took a good stainless brush and polished the inside of the angled and then welded a bead right down the inside. No worries about air contamination since there is no opening to the other side. No back chipping necessary. Wire-feed? Mig? Tig? Bronze weld stick?? My work pieces and experimental pieces were MIG welded with a big blue 212 is 5000 series wire (I can never remember without looking it up) on 5052 ..125 sheet. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Fold down swim platform | ASA | |||
Trailer - Telescoping or Fold Away tongue? | General | |||
Flex-o-fold propellors | Cruising | |||
Plans for a fold out cockpit table | Cruising | |||
Fold-up Canoe? | Boat Building |