Home |
Search |
Today's Posts |
#1
posted to alt.sailing.asa
|
|||
|
|||
Anti syphon vents
After a long break, back to usenet. Have you ever been told something by an "expert", but you're not sure if what they say is right? The thoughts of my peers would be appreciated. About to do a bit of plumbing on "Hinewai" and was chatting over a beer to the chap who does loads of plumbing work on the boats in our marina. He charges like a wounded bull, hence the chat over a beer and doing it myself. We've just cut a new through-hull which feeds a three way manifold. Manifold Exit 1 will go to a sea water foot pump for the sink - the tap will be not that far above waterline. Sink empys into a grey water sump tank (below waterline) which is then pumped overboard via a high loop, joining the exhaust out pipe just before it comes out though the transom. The loop in the lazerette is unvented since it's not connected to any below waterline water-in thingy. Manifold Exit 2 will go to the heat exchange pump on the new Isotherm Refrigeration Manifold Exit 3 will go to the watermaker. The thru hul is, of course, valved - each manifold outlet will have a manual valve. Once the water's done its stuff with the fridge and watermaker, the waste pipes will both link, below waterline, into grey water out system on the output side of the sump tank and pump - back flow will be stopped by either a non-return or/and a manual valve. The pumps for both fridge and watermaker have enough balls to get the waste past the loop in the lazerette. My plan was to put vented loops on: 1. The output side of the foot pump 2. The output side of fridge pump 3. The output side of the boost pump to the watermaker serious pump. Then, at least, should we lose any pipe work on the output side of the (below waterline) pumps, we wouldn't sink. I can't see any time manifold outlets 1 & 3 would be open when we are not aboard, but we might be sleeping. There will certainly be times I can see that the fridge will be running when we're on-shore. My question to "the plumber' was whether I should consider a vented loop on the output side of the main watermaker pump - not in the high pressure bit, but in the brine waste. While the O tubes are above waterline, the output pipe dips below waterline to marry into the grey water output. His advice was not to bother with vented loops for the sink and watermaker if we'd be there when those valves are open. In some ways that makes sense (but.. zzzzz), but I was blown away when he said I didn't need any vented loops at all with any of these pipeworks as long as I double clipped all joints and put a vent on the lazerette loop. He's seen the planned set up when he quoted me for the job, but that seems like a crock of sh*t to me. I'd welcome your thoughts (although still mean to put vented loops in as planned). Any thought's on the brine side of the watermaker? I must admit I can't see any need to vent the loop in the lazerette, but maybe I'm totally confused over this whole issue. Thanks Peter Ocean Odyssey Australia www.oceanodyssey.net "Do not measure your life by the number of breaths you take, Rather by the number of times life just takes your breath away" |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Anti syphon vents | Cruising | |||
Anti syphon vents | General | |||
Anti syphon vents | Boat Building | |||
Where to get these vents - With a link to pictures | Boat Building | |||
Where to get these vents - With a link to pictures | Boat Building |