LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Martin Baxter
 
Posts: n/a
Default Outboard motor storage?


Since we've got another going on outboards, another question comes to mind viz-a-viz two stroke vs four stroke storage.

Do the four stroke motors have a dry sump, if not can you store the motor in any position without loss of crankcase oil?

Cheers
Marty

  #2   Report Post  
Scott Vernon
 
Posts: n/a
Default

Wet sumps.
IIRC, my Honda 8 owners manual, they say to set it down only on it's
carry handle, which gives it a slight downward tilt, but for long term
storage is best to have upright.

Scotty


"Martin Baxter" wrote in message
...

Since we've got another going on outboards, another question comes

to mind viz-a-viz two stroke vs four stroke storage.

Do the four stroke motors have a dry sump, if not can you store the

motor in any position without loss of crankcase oil?

Cheers
Marty



  #3   Report Post  
DSK
 
Posts: n/a
Default

Martin Baxter wrote:
Since we've got another going on outboards, another question comes to
mind viz-a-viz two stroke vs four stroke storage.

Do the four stroke motors have a dry sump, if not can you store the
motor in any position without loss of crankcase oil?


The ones I know of don't have a dry sump. We had a Honda for years and
it had storage feet molded into one side of the case. Laying it down was
OK as long as it was level on these feet (according to the owners
manual). We stored it that way twice, for a couple of months, and it was
fine.

IIRC older Yamahas have the same sort of deal.

Fresh Breezes- Doug King

  #4   Report Post  
Scott Vernon
 
Posts: n/a
Default

Doug's right. Now I remember. Two small lugs (feet), not the handle
to set on.

Scotty

"DSK" wrote in message
. ..
Martin Baxter wrote:
Since we've got another going on outboards, another question comes

to
mind viz-a-viz two stroke vs four stroke storage.

Do the four stroke motors have a dry sump, if not can you store

the
motor in any position without loss of crankcase oil?


The ones I know of don't have a dry sump. We had a Honda for years

and
it had storage feet molded into one side of the case. Laying it down

was
OK as long as it was level on these feet (according to the owners
manual). We stored it that way twice, for a couple of months, and it

was
fine.

IIRC older Yamahas have the same sort of deal.

Fresh Breezes- Doug King



  #5   Report Post  
Michael
 
Posts: n/a
Default

Nope, four stroke or two there are reasons to store them in a certain way
'starting' with a good fresh water flush. Always refer to your owners
manual and follow it implicitly. For mine there are two positions for
storage and only two but for long term that is reduced to one configuration.

M.

"Martin Baxter" wrote in message
...

Since we've got another going on outboards, another question comes to mind

viz-a-viz two stroke vs four stroke storage.

Do the four stroke motors have a dry sump, if not can you store the motor

in any position without loss of crankcase oil?

Cheers
Marty





  #6   Report Post  
Martin Baxter
 
Posts: n/a
Default

Michael wrote:
Nope, four stroke or two there are reasons to store them in a certain way
'starting' with a good fresh water flush. Always refer to your owners
manual and follow it implicitly. For mine there are two positions for
storage and only two but for long term that is reduced to one configuration.


Michael:

What I was getting at is that I can throw my two stroke in a locker any which way I like, (having drained the little
gas from the carb.) and it doesn't really matter. If I do the same with a four stroke without draining the oil it would
seem likely that there is going to a problem with a lot of oil going where it is not wanted.

Cheers
Marty

------------ And now a word from our sponsor ------------------
Want to have instant messaging, and chat rooms, and discussion
groups for your local users or business, you need dbabble!
-- See http://netwinsite.com/sponsor/sponsor_dbabble.htm ----
  #7   Report Post  
Bobsprit
 
Posts: n/a
Default

It's the difference between a lubber with a boat, and a
sailor.


You can bet your life that Martin's toolbox is a rusty mess. He uses a tool
until it's dead, then runs to Walmart for more cheapie tools.

RB
  #8   Report Post  
Bobsprit
 
Posts: n/a
Default

Secondly I'm with the Crapton on
this one, I have a sail boat, not a motor boat, I don't rely on a motor, if

you want to rely on a motor then

If an outboard is part of a sailing boat's inventory it should be maintained to
a high standard, just like anything else on board. "Relying" on a dinghy motor
(or not) is not the issue.
Martin, you're an idiot. If you must troll foolishly, why not try it elsewhere?

RB
  #9   Report Post  
Bobsprit
 
Posts: n/a
Default

Try a little intellectual honesty sometime, if you dare.


This is Donal you're talking about. Let's keep our expectations grounded!

RB
  #10   Report Post  
Bobsprit
 
Posts: n/a
Default

If you have an outboard motor for your dinghy, it should be cared for
like any other tool.


The "man" sails a Beneteau. Let's hope he has a dinghy AND a liferaft!

RB


 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
dead outboard? Evan Gatehouse Cruising 11 June 16th 04 07:34 PM
Outboard Overboard!!!! Bobsprit ASA 20 June 14th 04 05:24 PM
Tiller and outboard - which one controls ? Sven General 6 December 6th 03 02:15 AM
Recommend HP + mounting outboard - 27' Sailboat? Dave W Boat Building 3 October 1st 03 01:54 AM
Converting I/O to Outboard with Jack Plate Mile Sullivan General 5 September 19th 03 02:59 AM


All times are GMT +1. The time now is 09:26 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 BoatBanter.com.
The comments are property of their posters.
 

About Us

"It's about Boats"

 

Copyright © 2017