Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Cicero
 
Posts: n/a
Default


"Howie" wrote in message
...
Hi all,

I am struggling to work out how to repair a section of plywood
which was damaged and subsequently became a bit waterlogged.

This is a section approx the size of my hand and I can rub it
down to undamaged, hard wood all around.

However, as this is a section of my boat wheelhouse, and as such,
built from a very large single sheet of ply, - and as I am not a
carpenter by any stretch of the imagination, I really don't want
to cut this section out or attempt to replace the whole sheet.

Can anyone give me a hint about rebuilding just this single layer
as a good, strong, invisible repair. The finish is paint, - so I
_can_ cover up, - a bit :-)

Appreciate any help,

Regards,

H.


--
Howard Coakley


=================
If you can't do it yourself it would be worth getting someone to 'router'
out the damaged section to a depth of about 6mm. Then glue in a piece of
6mm plywood using waterproof glue.

Car body filler (as suggested by another poster) might fall out if there is
any moisture in the underlying wood, but would be worth trying if you think
you can get the damaged part completely dry.

Cic.


  #2   Report Post  
Geoff
 
Posts: n/a
Default

Cicero wrote:


I am struggling to work out how to repair a section of plywood
which was damaged and subsequently became a bit waterlogged.

This is a section approx the size of my hand and I can rub it
down to undamaged, hard wood all around.

However, as this is a section of my boat wheelhouse, and as such,
built from a very large single sheet of ply, - and as I am not a
carpenter by any stretch of the imagination, I really don't want
to cut this section out or attempt to replace the whole sheet.

Can anyone give me a hint about rebuilding just this single layer
as a good, strong, invisible repair. The finish is paint, - so I


There is a trick with a router that would do this, impossible to explain
but,
http://www.trendmachinery.co.uk/libr...es/PAGE133.PDF
under "Timber repair kit" gives some idea.
With the right cutter/bush combo it's dead easy. You make a jig/pattern
to suit the damaged area.
cheersandgone
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
rec.boats.paddle sea kayaking FAQ [email protected] General 0 January 28th 05 05:46 AM
rec.boats.paddle sea kayaking FAQ [email protected] General 0 April 17th 04 12:28 PM
rec.boats.paddle sea kayaking FAQ [email protected] General 0 February 16th 04 10:02 AM
rec.boats.paddle sea kayaking FAQ [email protected] General 0 January 16th 04 09:19 AM
rec.boats.paddle sea kayaking FAQ [email protected] General 0 December 15th 03 09:48 AM


All times are GMT +1. The time now is 08:14 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 BoatBanter.com.
The comments are property of their posters.
 

About Us

"It's about Boats"

 

Copyright © 2017