| Home |
| Search |
| Today's Posts |
|
#1
posted to rec.boats
|
|||
|
|||
shaft aligned and engine mounts fastened
FINALLY, got the engine output shaft and prop shaft and installed new
lag screws into the engine stringers on my Yanmar 2GM on my 28' sailboat. Ran her at near full rpm tied to dock and she seemed ok. Next, I gotta re-do the roller furler that for some reason wont allow me to pull the furling sail up the slide. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Engine/prop shaft alignment | General | |||
| Aligning engine to shaft(13 hp yanmar 2gmf on sailboat) | General | |||
| Water coming out of shift shaft when running engine on muffs. | General | |||
| Hydraulic engine mounts on an '82 OMC 3.8L V6 | General | |||
| Anybody ever converted a lawnmower or dirtbike engine to a inboard shaft and propeller setup? | Boat Building | |||
Linear Mode
