| Home |
| Search |
| Today's Posts |
|
#4
posted to rec.boats
|
|||
|
|||
Sea Ray 170 Starter
jamesgangnc wrote:
wrote in message ... How hard is it to replace the starter ? Are there shims to line up the gears ? Can this starter be re built in an automotive starter shop ? How much room there is to work in your particular boat drives that answer. I presume you have an i/o, not an outboard. Move any stuff out of the way and see how difficult it is to reach the bolts. Depending on the engine there will be 2 or 3 bolts to remove as well as one or more wires. The bolts will probably be coming up from the bottom. Usually the wires are a bit easier to get at but if they are difficult on your boat sometimes you can remove the start form the engine and then move it to make the wires easier to get at. Disonnect the battery before starting work as the big wire to the starter will be hot even though the boat is turned off. An automotive shop should be able to rebuild it for you but that might not be any cheaper. Presumably you have done enough diagnosis to confirm it is the starter? Not cranking can be any number of problems not all of which are fixed by replacing the starter. True. Start with the solenoid. -dk |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| new starter | Boat Building | |||
| new starter | Boat Building | |||
| I/O Starter | General | |||
| starter? | Cruising | |||
| I think the starter is gone now! | General | |||
Threaded Mode
