I have a 15' 500 pound sailboat. How much weight would be required for a
secure mooring in a small lake?

"Jessica" wrote in message
...
I have a 15' 500 pound sailboat. How much weight would be required for a
secure mooring in a small lake?



I don't know. However, I can guess. I figure the concrete blocks used to
moor 30,000 lb. and larger boats in an ocean harbor probably weigh about
600 lbs., I suspect it won't take too much to hold your 500 lb. sailboat.
The mooring blocks sink into the muck on the bottom, adding to their holding
strength that is from an angle.

Eisboch

On Tue, 08 Apr 2008 22:49:32 GMT, "Jessica" wrote:

I have a 15' 500 pound sailboat. How much weight would be required for a
secure mooring in a small lake?

The old rule of thumb for mooring weight is 10 pounds per foot of boat
length. If you are on a small protected lake you could probably get
by with less unless your area is prone to very strong wind storms.

On Apr 9, 12:30*am, Wayne.B wrote:
On Tue, 08 Apr 2008 22:49:32 GMT, "Jessica" wrote:
I have a 15' 500 pound sailboat. *How much weight would be required for a
secure mooring in a small lake?

The old rule of thumb for mooring weight is 10 pounds per foot of boat
length. *If you are on a small protected lake you could probably get
by with less unless your area is prone to very strong wind storms.

Hmm, that's quite a bit different than Eisboch's take on things. I'm
going to keep track of this thread to see what shakes out, it's
something I know little about and want to know more!

wrote in message
...
On Apr 9, 12:30 am, Wayne.B wrote:
On Tue, 08 Apr 2008 22:49:32 GMT, "Jessica" wrote:
I have a 15' 500 pound sailboat. How much weight would be required for a
secure mooring in a small lake?

The old rule of thumb for mooring weight is 10 pounds per foot of boat
length. If you are on a small protected lake you could probably get
by with less unless your area is prone to very strong wind storms.

Hmm, that's quite a bit different than Eisboch's take on things. I'm
going to keep track of this thread to see what shakes out, it's
something I know little about and want to know more!

---------------------------

Remember .... I said I didn't know and took a guess based on what I see in a
couple of local harbor mooring fields.
I am doubtful that the blocks weigh much more than 600 lbs, based on the
floating contraptions used to set them or haul them out.

Eisboch

"Eisboch" wrote in message
...

wrote in message
...
On Apr 9, 12:30 am, Wayne.B wrote:
On Tue, 08 Apr 2008 22:49:32 GMT, "Jessica" wrote:
I have a 15' 500 pound sailboat. How much weight would be required for a
secure mooring in a small lake?

The old rule of thumb for mooring weight is 10 pounds per foot of boat
length. If you are on a small protected lake you could probably get
by with less unless your area is prone to very strong wind storms.

Hmm, that's quite a bit different than Eisboch's take on things. I'm
going to keep track of this thread to see what shakes out, it's
something I know little about and want to know more!

---------------------------

Remember .... I said I didn't know and took a guess based on what I see in
a couple of local harbor mooring fields.
I am doubtful that the blocks weigh much more than 600 lbs, based on the
floating contraptions used to set them or haul them out.

Eisboch




Wayne is much closer than I according to this:

Minimum deadweight mooring weight:

Vessel length:

10 - 17 1000 lbs.
18 - 26 1500 lbs.
27 - 35 3000 lbs.
36 - 45 4000 lbs.
45 - 55 5000 lbs.

Submerged Weight Calculations

Concrete = required weight /.55 (example 1000 lbs./.55 = 1818 lbs.)
Granite = required weight /.64

http://www.harbormasters.org/rockport/mooring.shtml



Eisboch

"Eisboch" wrote in message
...

"Eisboch" wrote in message
...

wrote in message
...
On Apr 9, 12:30 am, Wayne.B wrote:
On Tue, 08 Apr 2008 22:49:32 GMT, "Jessica" wrote:
I have a 15' 500 pound sailboat. How much weight would be required for
a
secure mooring in a small lake?

The old rule of thumb for mooring weight is 10 pounds per foot of boat
length. If you are on a small protected lake you could probably get
by with less unless your area is prone to very strong wind storms.

Hmm, that's quite a bit different than Eisboch's take on things. I'm
going to keep track of this thread to see what shakes out, it's
something I know little about and want to know more!

---------------------------

Remember .... I said I didn't know and took a guess based on what I see
in a couple of local harbor mooring fields.
I am doubtful that the blocks weigh much more than 600 lbs, based on the
floating contraptions used to set them or haul them out.

Eisboch




Wayne is much closer than I according to this:

Minimum deadweight mooring weight:

Vessel length:

10 - 17 1000 lbs.
18 - 26 1500 lbs.
27 - 35 3000 lbs.
36 - 45 4000 lbs.
45 - 55 5000 lbs.

Submerged Weight Calculations

Concrete = required weight /.55 (example 1000 lbs./.55 = 1818 lbs.)
Granite = required weight /.64

http://www.harbormasters.org/rockport/mooring.shtml



Eisboch




I believe the requirements for your favorite harbor are #2000 granite
minimum.
The calculations you listed seem reasonable.
Different harbors have different ground tackle regulations in keeping with
local conditions. When in doubt consult the local authorities.

On Wed, 9 Apr 2008 10:04:27 -0400, "Eisboch" wrote:

Wayne is much closer than I according to this:

Minimum deadweight mooring weight:

Vessel length:

10 - 17 1000 lbs.
18 - 26 1500 lbs.
27 - 35 3000 lbs.
36 - 45 4000 lbs.
45 - 55 5000 lbs.

Submerged Weight Calculations

Concrete = required weight /.55 (example 1000 lbs./.55 = 1818 lbs.)
Granite = required weight /.64

http://www.harbormasters.org/rockport/mooring.shtml

The rule of thumb that I quoted (10 lb/ft) is for steel mushroom
moorings. Since they have a higher density than rock or concrete, and
tend to dig in faster, you can get by with less weight.

wrote:
On Wed, 9 Apr 2008 09:54:26 -0400, "Eisboch" wrote:

wrote in message
...
On Apr 9, 12:30 am, Wayne.B wrote:
On Tue, 08 Apr 2008 22:49:32 GMT, "Jessica" wrote:
I have a 15' 500 pound sailboat. How much weight would be required for a
secure mooring in a small lake?
The old rule of thumb for mooring weight is 10 pounds per foot of boat
length. If you are on a small protected lake you could probably get
by with less unless your area is prone to very strong wind storms.
Hmm, that's quite a bit different than Eisboch's take on things. I'm
going to keep track of this thread to see what shakes out, it's
something I know little about and want to know more!

---------------------------

Remember .... I said I didn't know and took a guess based on what I see in a
couple of local harbor mooring fields.
I am doubtful that the blocks weigh much more than 600 lbs, based on the
floating contraptions used to set them or haul them out.

Eisboch


A block mooring needs to be a lot heavier than a mushroom in my
opinion. The mushroom is designed to bury itself, which increases it's
holding power.




Back in the 1950s, we used 100-pound mushroom anchors and chain with
stainless steel beer barrels for moorings in Long Island Sound. These
were typically for boats to about 21' LOA. They held, even in
hurricanes, though anyone with a brain moved his boat inshore or onshore
when a big storm was a'brewing. We'd yank the moorings at the end of the
season.

"HK" wrote in message
. ..
wrote:
On Wed, 9 Apr 2008 09:54:26 -0400, "Eisboch" wrote:

wrote in message
...
On Apr 9, 12:30 am, Wayne.B wrote:
On Tue, 08 Apr 2008 22:49:32 GMT, "Jessica" wrote:
I have a 15' 500 pound sailboat. How much weight would be required for
a
secure mooring in a small lake?
The old rule of thumb for mooring weight is 10 pounds per foot of boat
length. If you are on a small protected lake you could probably get
by with less unless your area is prone to very strong wind storms.
Hmm, that's quite a bit different than Eisboch's take on things. I'm
going to keep track of this thread to see what shakes out, it's
something I know little about and want to know more!

---------------------------

Remember .... I said I didn't know and took a guess based on what I see
in a couple of local harbor mooring fields.
I am doubtful that the blocks weigh much more than 600 lbs, based on the
floating contraptions used to set them or haul them out.

Eisboch


A block mooring needs to be a lot heavier than a mushroom in my
opinion. The mushroom is designed to bury itself, which increases it's
holding power.




Back in the 1950s, we used 100-pound mushroom anchors and chain with
stainless steel beer barrels for moorings in Long Island Sound. These were
typically for boats to about 21' LOA. They held, even in hurricanes,
though anyone with a brain moved his boat inshore or onshore when a big
storm was a'brewing. We'd yank the moorings at the end of the season.

An old favourite around here was an engine block... or a 45 gal barrel
filled with concrete and steel rebar sticking out to prevent rolling.