| Home |
| Search |
| Today's Posts |
|
#20
posted to rec.boats
|
|||
|
|||
trailer setup
"Calif Bill" wrote in message ink.net... Move the axles. Just measure from the back and make sure both sides are the same. IF the boat is at the back of the bunks, that part is OK and you do not need to move a winch stand. Easier said than done. That involved cutting off the tabs and welding on new ones. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Mac26X fit for all waters | Cruising | |||
| Mac26X fit for all waters | ASA | |||
| tailpipe in saltwater when launching | General | |||
| ramp launching stories (These are funny!) | General | |||
| Where to find ramp stories? | General | |||
Threaded Mode
