| Home |
| Search |
| Today's Posts |
|
#1
posted to rec.boats
|
|||
|
|||
OMC Stringer Manual Trim?
Does anyone have any experience with Manually trimming an older OMC 400
with no power trim? I would assume that you could attempt to trim it some by adjusting the jack screw on the front motor mount. Just not sure what effects it would have if any. Looking to see if it has been done. |
|
#2
posted to rec.boats
|
|||
|
|||
|
OMC Stringer Manual Trim?
"CM" wrote in message ups.com... Does anyone have any experience with Manually trimming an older OMC 400 with no power trim? I would assume that you could attempt to trim it some by adjusting the jack screw on the front motor mount. Just not sure what effects it would have if any. Looking to see if it has been done. AFAIK The jack screw is the only adjustment. Tilting the drive out stresses the ball gears and causes excessive wear on them. Jim |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Trim / Tilt issue on Outboard | General | |||
| manual tilt trim | General | |||
| Trim Woes | General | |||
| Stringer problems?? | General | |||
| Need a suggestion for the trim wiring on my boat | General | |||
Linear Mode
