About Us

Chuck Gould

wrote:
Chuck Gould wrote:
wrote:
Got a table for the Sun Tracker from Overton's... stand diameter is
smaller than the factory holders. First thought was to use duct tape
to build it up, but that would most likely get messy quick. Think that
high temp tape (shiney aluminum looking stuff) would work okay? Other
ideas?

Order a smaller socket?

It came with a smaller one... but I was trying to keep both sockets the
same size as we have another table and may want to switch them around.

If you can take careful measurements, figure out the size of the insert
you need to bush the current socket down to the required diameter.

Your local plastics shop will make you a plastic bushing that you can
put into the larger socket to fill up the gap between the socket and
the leg. Probably cost you $30 or so.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
santana 21 swing keel stuck up any ideas	Barton Garber	General	1	August 4th 04 10:38 PM
py 26 rubrail cracking and burner alcohol replacement ideas	Michael Droege	ASA	3	February 24th 04 01:48 PM
Ideas on Motor/Tranny issues	Mark Davis	General	4	February 10th 04 03:26 AM
Important news For all webmaster,newsmaster: HACK ATTEMPT?	Capt. Frank Hopkins	General	0	October 10th 03 06:38 PM
Need Floatation ideas for a new canoe	Stroyer	General	7	August 21st 03 07:54 AM