Home |
Search |
Today's Posts |
#6
![]()
posted to rec.boats
|
|||
|
|||
![]() "Gene Kearns" wrote in message ... On 26 Jun 2006 11:26:54 -0700, jiminfl penned the following well considered thoughts to the readers of rec.boats: No doubt about it. You have a bad switch. Try Walmart or an auto parts store. If you live near water, try a marine store. Jim BlueThunder wrote: Please excuse my ignorance; I'm not a mechanic. I have a 1984 18 ft open bow Rinker with a Mercruiser 185 I/O engine. Sometimes when I turn the ingition switch, nothing happens (no clicking or anything). After I try it 3 or 4 times, the engine starts fine. Is it likely a bad ignition switch? As far as I know, it's the original switch. If it is the switch, ideas on where to get a new one? Whoa....... dood..... there is a LOT of doubt about it...... It could be anything from the ignition switch to a sticking starter solenoid.... .... time to diagnose, not swap parts.... Except, the OP indicated that the only thing he exercised the contacts of was the ignition switch. He didn't indicate that he slapped anything else around to get it to start. Did you, OP? Like wiggle the gearshift? (neutral switch). Eisboch |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Boat Power Trim Up Switch Not Working - Help! | General | |||
Thunderbolt Ignition - Starts sometimes | General | |||
Chrysler 120 hp ignition problem | General | |||
A/B Battery Switch | General | |||
shift interrupt switch | General |