Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
Yamaha outboard shift rod
I dropped the lower unit on a 1989 Yamaha V6 to replace the water
pump. While removed I had the mech replace seals and bearings. He had to apply heat to the lower unit to disassemble (corrosion). Setting on the bench the transmission shifts fine from forward to neutral to reverse. Once installed, with the motor running, it is difficult to shift into forward. Pull the control lever to the neutral position, the transmission stays in forward. Pull the control lever to the reverse position, the transmission goes into neutral. You cannot get to reverse. With the motor not running, the transmission shifts fine. Any suggestions? |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
WTB Shift Rod 1985 Yamaha 150 | General | |||
Small Yamaha fresh water flush | General | |||
How to Detach Shift Linkage to Lower Unit | General | |||
A suitable outboard for a Intex Seahawk 500 ? | General | |||
Yamaha 60 rpm problem | General |