Home |
Search |
Today's Posts |
#11
![]()
posted to alt.rv,alt.rv.pop-up-trailers,rec.boats,alt.rv.pop-up-trailers
|
|||
|
|||
![]() "tobe" wrote in message . .. Lengthening the trailer tongue is a different matter from lengthening the distance from the ball on the ball mount to the tow vehicle. In the former, the center of gravity of the boat/trailer is farther from the center of gravity of the tow vehicle, but that by itself doesn't make much difference in towing and handling (all else being equal). However, if the distance from the tow vehicle to the ball mount is longer, any sway in the trailer has much more of an effect on the handling of the tow vehicle. Think of a lever and fulcrum. The longer the lever from the fulcrum, the more movements are magnified. Common lengths, from the hitch pin hole to the ball hole, are around 8 inches, with the longest I have commonly seen about 11 inches (and the shortest something like 6 inches). Not all hitches have the same distance from the back end of the hitch to the end of the vewhicle (bumper...), and, of course, not all vehicles have the same distance from the center of gravity or the rear axle to the hitch. Therefore, I would imagine that the length of the ball mount in the ranges commonly available will not have much effect on towing. The most important factor is probably tight turns, with the trailer not running into the tow vehicle (pretty hard to do with a standard pop-up configuration!). Note that there are hitch ball mount 'extenders' available in lengths up to 18". These usually state in the fine print that the maximum towed weight should be reduced by 1/3 if using these, and I would also imagine that any sway in the trailer could be dangerously amplified. Agreed. Ideally, you want the actual ball mounting position as close to the rear axle of the tow vehicle as practically possible. If you ever take note of the guys who transport mobile homes for a living, they are generally driving a single axle road tractor that has been modified to put the ball mount as close to the rear axle as possible. Someone in this thread mentioned an "obscenely expensive" hitch that makes believe the hitch point is @ or near the rear axle, good thinking. This is why, with an OTR history, I chose to go 5th wheel. I've seen too many trailers towed by ball hitch where the tail started wagging the dog. I wasn't aware they made ball mount extenders, but the very thought scares me. Same thought as going down the road with my 16K slider in the maneuvering position. Ladies & gentlemen, I haven't lurked here long, so if my statements are objectionable, feel free to fire away. Cut my teeth in Usenet & always wear the flame retardant undies. I'm making statements about things I think I can contribute to, but there's a whole lot about RVing I DON'T know, and may likely ask some stupid(to some) questions(then again, the only stupid question is . . . ). -- Nahmie The only road to success is always under construction. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
How Long the Shaft of an Auxiliary Motor Should I Get? | Cruising | |||
How Long the Shaft of an Auxiliary Motor Should I Get? -- 2nd Try | General | |||
How Long the Shaft of an Auxiliary Motor Should I Get? | General | |||
Clear Lake vs Long Island Sound! | ASA | |||
Length of a boat | Boat Building |