Wayne.B wrote:
On Tue, 24 Jan 2006 20:34:46 -0500, Larry wrote:


No valves. Intake ports and exhaust ports open as the piston
passes over them near BDC when the blower recharges the air and
blows out the dead gases.


That's what I thought but everyone else says there are exhaust valves
in the head.

There are valves.
Check:
http://www.yachtsurvey.com/comparing_diesel_types.htm

Courtesy of Detroit diesel!

Gaz

Gary wrote in news:C1EBf.325410$2k.236563@pd7tw1no:

There are valves.
Check:
http://www.yachtsurvey.com/comparing_diesel_types.htm

Courtesy of Detroit diesel!



He's right....Sorry.

Wow!! This goes on and on.

As most everyone has said the most likely culprit is fuel system related.
In my experience air leaks are very rare except when the engines have been
recently serviced. If this started after servicing the fuel filters an air
leak is very probable.

Injector tips are another possibility. BTW, injector timing is critical to
a DDA running well. You should probably invest the few dollars for a timing
gage. If you own the engines for a while you'll need one.

These engines are so simple and easy to work on that you would do well to
take a course on them. You could learn everything you'd ever need to know
in about a 40 hour course. That would include a complete teardown and
reassembly phase with a tune up. IMO, these are wonderful engines for the
DIY inclined owner.

Butch
"Larry" wrote in message
...
Gary wrote in
news:C1EBf.325410$2k.236563@pd7tw1no:

There are valves.
Check:
http://www.yachtsurvey.com/comparing_diesel_types.htm

Courtesy of Detroit diesel!



He's right....Sorry.

On Wed, 25 Jan 2006 14:49:55 +0000, Butch Davis wrote:

Wow!! This goes on and on.

As most everyone has said the most likely culprit is fuel system related.
In my experience air leaks are very rare except when the engines have been
recently serviced. If this started after servicing the fuel filters an air
leak is very probable.

Injector tips are another possibility. BTW, injector timing is critical to
a DDA running well. You should probably invest the few dollars for a timing
gage. If you own the engines for a while you'll need one.

These engines are so simple and easy to work on that you would do well to
take a course on them. You could learn everything you'd ever need to know
in about a 40 hour course. That would include a complete teardown and
reassembly phase with a tune up. IMO, these are wonderful engines for the
DIY inclined owner.

Butch

First good advise that has been given. The tools are availible here.
You will only need the one tool for the type injector that is in your engine.

http://buy1.snapon.com/catalog/tools...e=snapon-store

I own a set of four that I've had for about thirty-five years.
They won't go bad, and you will only need one.

alt.binaries.pictures.sports.ocean, has some info.