About Us

wrote:
Have a 1973 Johnson 115v4. She had a intermitted starting problem.
Replaced Starter and Solonoid
Last year we had the carbs rebuilt.

When shes running.. She runs great, smooth all that.. Its starting
thats the main problem.

Starting- If the battery is fully maxed on charge it will start. but
it has to be a really fresh new battery or maybe a 2nd. But when we
try to start it on the lake with a less than 100% fresh battery (say
90%).. It wont start unless we wait awhile or we connect a jumper. I
have sprayed starter fliud at these moments when it wont fire and
nothing. . I can pull a plug andits either weak or no fire. Last
season we connected 2 batterys together. This worked for awhile.. it
would start every time for a time. Now thats not working. And
sometimes now not even jumping isstarting it.

I was told by a shop mechanic its most likely a weak stator. And this
has the symptoms of that because it requires high cranking RPM for the
plugs to show fire.

Also been told it could be the power pack.

So Far my plan is to replace the stator to start with. Any way I can
test the power pack? I have a multimeter and some other tools.

Thanks

Before you go taking this all apart, check the resistance of the
sensor coils. Disconnect the leads (they are Black w/White & White
w/Black) from posts #2 & #4, and #9 & #12 of the power pack. They
should be 6-10 ohms, and not shorted to ground (~ ohms). The charge
coils are tested by checking the resistance of the brown & brown/yellow
leads (terminals #7 & #8) for 550-700 ohms, and again no shorts to ground.

I have not seen the sensor coils or charge coils fail nearly as much as
the power packs. The power packs are available from NAPA or Sierra as
#18-5753 (needed for the first non-OEM replacement) with all the
hardware, #18-5756 w/o the hardware. If one or both of the sensors is
faulty, the timer base needs to be replaced, this is seperate from the
stator/charge coil assembly. The flywheel nut spec is 100-105 ft. lbs.

What we've seen is that the power pack warms up in the sun while the
cover/hood is off, starting the engine and running fine, until the next
cold start. Replacing the pack usually does the trick. Be sure EVERY
screw and terminal is clean and tight before re-attaching the battery to
the outboard.

Good Luck!

Rob

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Removing flywheel on 1973 Johnson 115	[email protected]	General	4	May 5th 04 07:06 PM
1973 v4 115 Johnson starting problem... Ideas	[email protected]	General	12	February 25th 04 06:37 PM
Johnson outboard problem	Garland Gray II	General	10	October 3rd 03 07:45 PM
Newbie Q - old Johnson 40 problem	Booms	General	6	September 20th 03 03:15 PM
back with a problem now	Nancy	General	14	August 2nd 03 05:43 AM

Menu

About Us