About Us

On Tue, 21 Dec 2004 14:07:46 GMT, (Tom)
wrote:

I'm considering purchasing a '97 Hydra-Sports Ocean 22 and wonder if
anyone has any experience with this boat. I'll use it primarily for
bay fishing with occasional offshore trips in the Gulf. My main
concern is construction - does anyone know if the transom/stringers
are wood or composite? Secondary is ride - especially in 4-6' seas.
Also wondering about the Evinrude 200 Ocean Pro ('97 as well). Any
advice would be greatly appreciated.

Highly recommended for the type of fishing you contemplate. The
offshore thing in the Gulf is always problem, but the nice thing is
you can make the run back in a hurry. There is plenty of fishing room
on the foredeck - the aft deck is problematic unless you have the
runabout/walkthru version in which case, the reverse it true.

It's a little twitchy in terms of stability when running, but the ones
that I've ridden in and fished out of were more than adequate. I
wouldn't press my luck with more than three folk fishing at the same
time. As always, engine trim on boats of this class has a lot to do
with how the ride is. On boats that I've been on, that does not seem
to be a problem like it is with my Ranger which is a comparable boat.

The problem with this boat isn't the stringers, but the transom, in
particular around the engine mounts. Minor stress cracks where the
engine is mounted is acceptable, but stress cracks along the top of
the transom where the engine is mounted aren't.

You might want to tap out the bottom for blisters or have it looked
over by a pro. This is not a normal problem for Hydra Sports, but it
pays to be sure. If this boat has hydraulic steering, check the hoses
for cracks and leaks at the ram.

With regard to the engine, this was a transition year for
Evinrude/Johnson/OMC. Assuming that the engine has been running
relatively problem free since it was new, then I wouldn't worry about
it unless you have extreme hours on it. With engines of this vintage
and because it is a transition era Evinrude, it would be a good idea
to determine how many hours are on the engine, have it compression
checked, have a mechanic scope out the cylinders to check for
excessive wear, pull the lower unit and have the seals pressure tested
and just for the hell of it, changed anyway, prop shaft should be
mic'd to see if it's out of round or bent and change the gear oil just
because.

I would also check the trim fluid just to be sure.

Other than that, just be careful with the purchase, ask lot's of
questions, make sure this is what you really want and if the Fishing
Gods smile on you, you will have a pretty decent fishing boat.

Good luck.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Be on a new National Extreme Sports network television show	[email protected]	General	0	October 4th 04 12:20 AM
Info. on Hydra Sports Ocean	Bob	General	0	June 9th 04 10:36 PM
Advice	Shrory	General	2	February 18th 04 06:50 PM
Any advice for first-time gulf sailors?	Rob Laymon	General	5	January 3rd 04 04:56 AM
Sage restoration advice wanted (osmosis)	Angus Gratton	General	4	November 14th 03 06:04 PM

Menu

About Us