About Us

On 15 Oct 2004 17:28:42 -0700, (Art Coe) wrote:

Appreciate some thoughts on putting my outboard motor (30 hp
Mariner)back into service. I knew it would be out of operation for
awhile so I flushed it out good, ran the carb dry, changed the lower
unit oil, squirted some two stroke oil into the cylinders via the
spark plug holes and pulled the starter cord a couple of times.

Time slipped on by and the press of other things kept me away from my
boat. Now, when I'm ready to start using it again, I realize that 10
years have passed since I "serviced" it. I'm not sure how to proceed.
Do I have a piece of junk, suitable only as an anchor or scrap
aluminum? Should I simply get some fresh gas, hook up the battery and
try to fire it up? Should I tear it down and replace gaskets, pump
impeller, etc. before trying to fire it up?

Any advice appreciated.

I can tell you what I did with an '86 Johnson 75 that I put up in
similar fashion to what you did a couple of years ago.

I pulled the plugs, shot some WD-40 (CRC will also work) into the
cylinders, pulled it through a couple of times, some more WD, pulled
it through a few times, then more WD and gave it a good eight/ten
pulls, checked the spark the old fashioned way, put it in gear and
pulled it through a time or two, put the plugs back in and got ready

I didn't quite double the recommended mixture (I can't remember if it
was 100 or 50:1), but maybe about a 1/4 or so over so it would get a
little more oil than necessary. Put a little of the mixture into a
spray bottle and shot some into the carbs, then started her up.

Nice thing, a grunt or two and wham - started, roughed it'self out a
little bit, settled down and purred right along. I didn't push it out
of idle for about five minutes, then put a little load on it, let it
idle, then shut it off, took it to the lake and ran a tank full
through it.

Worked like a charm.

All the best,

Tom
--------------

"What the hell's the deal with this newsgroup...
is there a computer terminal in the day room of
some looney bin somewhere?"

Bilgeman - circa 2004

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Outboard Engine Advice Needed Please - Mercury 40HP	Submariner	General	16	June 24th 04 09:15 PM
more power to electric outboard motor	Tero	Electronics	3	June 9th 04 09:05 AM
electric outboard motor	Tero	UK Power Boats	1	June 8th 04 11:30 PM
Mounting pad for a large outboard motor - what material should it be made from?	Torre	Boat Building	2	November 14th 03 11:35 AM
Synthetic oil in a outboard engine ?	JG	General	6	August 20th 03 04:27 PM

Menu

About Us