On Saturday, April 11, 2020 at 5:25:40 PM UTC-4, wrote:
On Sat, 11 Apr 2020 12:41:03 -0400, Keyser Soze
wrote:


https://i.ibb.co/Fwjg6HY/9-C155203-2...81226-ECE7.jpg

Homemade snapcaps.

How did they get to be snap caps? Did you pull the bullets, dump the
powder, deprime them and replace the primer with some kind of HDPE or
something?
You probably should have drilled a hole or 2 in the case so you knew
they were dummies.

The bigger question is how did all this happen with the stay home and social distancing that's in place? And harry doesn't know which end of a press is the correct one, so his buddy didn't give him the run of his reloading shop.

Someone handed him the shells with the bullets pressed in and crimped and some rubber primer plugs, and told him to superglue them into the primer pockets. At best. He doesn't have a clue how to setup a die in a press.

Too funny.

On Sat, 11 Apr 2020 15:17:29 -0700 (PDT), Its Me wrote:

On Saturday, April 11, 2020 at 5:25:40 PM UTC-4, wrote:
On Sat, 11 Apr 2020 12:41:03 -0400, Keyser Soze
wrote:


https://i.ibb.co/Fwjg6HY/9-C155203-2...81226-ECE7.jpg

Homemade snapcaps.

How did they get to be snap caps? Did you pull the bullets, dump the
powder, deprime them and replace the primer with some kind of HDPE or
something?
You probably should have drilled a hole or 2 in the case so you knew
they were dummies.

The bigger question is how did all this happen with the stay home and social distancing that's in place? And harry doesn't know which end of a press is the correct one, so his buddy didn't give him the run of his reloading shop.

Someone handed him the shells with the bullets pressed in and crimped and some rubber primer plugs, and told him to superglue them into the primer pockets. At best. He doesn't have a clue how to setup a die in a press.

Too funny.

Surely you don't think Harry would tell a lie!
--

Freedom Isn't Free!