Home |
Search |
Today's Posts |
|
#2
![]()
posted to rec.boats
|
|||
|
|||
![]() |
#3
![]()
posted to rec.boats
|
|||
|
|||
![]()
On 9/8/2013 11:55 AM, BAR wrote:
In article , says... On Sun, 8 Sep 2013 00:11:15 -0400, BAR wrote: I have a Honda Prelude but I am not sure the hood has been open more than a few dozen times in 10 years I am not sure what is in there. ;-) I just put gas in it and drive it. Hopefully you have a 2.0 VTEC engine. My biggest problem wat the CV joint boots. That is the only engine they put in the Prelude from what I can tell. No problem with the boots so far. I assume they will sell me some "wrap around" boots when the time comes. I had an off-road excursion and my boots got torn up. Even after replacement of the inner shafts and new boots it still wasn't the same. Can you elaborate on "it still wasn't the same"? |
#4
![]()
posted to rec.boats
|
|||
|
|||
![]()
In article , says...
On 9/8/2013 11:55 AM, BAR wrote: In article , says... On Sun, 8 Sep 2013 00:11:15 -0400, BAR wrote: I have a Honda Prelude but I am not sure the hood has been open more than a few dozen times in 10 years I am not sure what is in there. ;-) I just put gas in it and drive it. Hopefully you have a 2.0 VTEC engine. My biggest problem wat the CV joint boots. That is the only engine they put in the Prelude from what I can tell. No problem with the boots so far. I assume they will sell me some "wrap around" boots when the time comes. I had an off-road excursion and my boots got torn up. Even after replacement of the inner shafts and new boots it still wasn't the same. Can you elaborate on "it still wasn't the same"? There was a bit of looseness in the steering when turning, and sometimes a thumping at high speed, over 80 MPH. The boots protect the CV joints from dirt and grime. When dirg gets into the CV joints they deteriorate rather quickly. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
The answer to aligning propellar shaft and drive/transmission shaft . . . | Cruising | |||
More getting the shaft(s) | Cruising | |||
Two props on one shaft? | Boat Building | |||
can I convert a long shaft small outboard to short shaft | General | |||
Dilemma; Extra long shaft to long shaft? | General |