On Wed, 29 May 2013 16:00:30 -0400, BAR wrote:

In article , says...

On Wed, 29 May 2013 08:34:19 -0400, John H
wrote:

On Tue, 28 May 2013 17:55:09 -0400, wrote:

After a full moon, it is usually a horseshoe crab shell
You can make an unusual pen from the tail so it is not a total loss.

http://gfretwell.com/ftp/ed%20horseshoe%20crab.jpg

Cool dog, but I was expecting a picture of the 'unusual pen'!!

John H.

http://gfretwell.com/ftp/pen.jpg

That is just a crab tail with a Bic(r)'s inards shoved into it.

Yup, but now that I've seen one, I want one. I'll have to keep my eyes open next time I'm playing at
the bay.

John H.
--

Hope you're having a great day!

In article ,
says...

On Wed, 29 May 2013 16:34:18 -0400, John H
wrote:

On Wed, 29 May 2013 16:00:30 -0400, BAR wrote:

In article , says...


http://gfretwell.com/ftp/pen.jpg

That is just a crab tail with a Bic(r)'s inards shoved into it.

Yup, but now that I've seen one, I want one. I'll have to keep my eyes open next time I'm playing at
the bay.


BAR is right, just a ball point refill
Two tricks, drill a tiny hole up in the pointy end just past where the
refill stops so it can breathe and open it up inside with a piece of
coat hanger wire that you beat a little flat on one end.
Use epoxy paste or good old JB Weld to hold it in place .

You need a pretty big horseshoe crab and they are getting harder to
find. There is some commercial taking of them and the habitat is being
hurt so they are becoming a species of special concern.
Fortunately they shed their shell in a molt so no crab was harmed in
this project. In fact if this wasn't a molted shell, getting the tail
hollowed out would be harder.

I remember when I was a kid spending summers on the FL west coast and
horseshoe crabs and their shells were everywhere.

In article , says...

On Wed, 29 May 2013 16:34:18 -0400, John H
wrote:

On Wed, 29 May 2013 16:00:30 -0400, BAR wrote:

In article , says...


http://gfretwell.com/ftp/pen.jpg

That is just a crab tail with a Bic(r)'s inards shoved into it.

Yup, but now that I've seen one, I want one. I'll have to keep my eyes open next time I'm playing at
the bay.


BAR is right, just a ball point refill
Two tricks, drill a tiny hole up in the pointy end just past where the
refill stops so it can breathe and open it up inside with a piece of
coat hanger wire that you beat a little flat on one end.
Use epoxy paste or good old JB Weld to hold it in place .

You need a pretty big horseshoe crab and they are getting harder to
find. There is some commercial taking of them and the habitat is being
hurt so they are becoming a species of special concern.
Fortunately they shed their shell in a molt so no crab was harmed in
this project. In fact if this wasn't a molted shell, getting the tail
hollowed out would be harder.

Don't the horseshoe crabs figure into the produciton of some drugs? I saw a program where
their blood has some special qualities.

http://www.horseshoecrab.org/med/med.html