Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
A long shaft Yamaha or Honda would be a good choice. It will run you about
$300 to $800 more than a Mercury or OMC (Johnson / Evinrude) but these are bullet-proof motors. The Yamaha's are little rare in some parts of the country but the Honda's are fairly available. If you are going out of country (like Mexico) you may want to consider a Mercury. Note too that the Nissan, Suzuki and Mercury (Mariner) small bore motors are actually made by Tohatsu. The size you want is about right for that boat. Anything from 4 to 8 hp should do the job... more costs more so think about your horsepower with the idea that it may be used for hours at a time if you have no wind and are impatient or if you have a lot of wind and need to handle the boat against it. Best; Chris "Bruce" wrote in message ... I need to buy an outboard for my San Juan 21 and not quite sure about how big to go. I would like a 4 stroke and I am thinking that about 5 HP would be a good size. Any comments about the different brands would be appreciated. Also, do I really need a "long shaft" motor. With the motor mount currently on the boat, it seems to me that any motor would easily bury the prop. Regards, Bruce |
#2
![]() |
|||
|
|||
![]()
"Chris Edmonson" wrote...
A long shaft Yamaha or Honda would be a good choice. It will run you about $300 to $800 more than a Mercury or OMC (Johnson / Evinrude) but these are bullet-proof motors. The Yamaha's are little rare in some parts of the country but the Honda's are fairly available. If you are going out of country (like Mexico) you may want to consider a Mercury. Note too that the Nissan, Suzuki and Mercury (Mariner) small bore motors are actually made by Tohatsu. The size you want is about right for that boat. Anything from 4 to 8 hp should do the job... Remember that the 8 HP motor is the same as the 10, except for max RPM and HP rating (about 105 lb for the Yamaha 4-stroke, long-shaft, 'sailboat special', IIRC). Therefore, it is MUCH heavier than the 5 HP. For the small boat, lighter is better! I had both Honda and Yamaha 10s on my San Juan 7.7. Either one was overkill in terms of HP. The Honda was lighter, but the Yamaha had a better feature set with the starter and alternator. I now have a Honda 4-stroke 2 on my SeaPearl 21 (much lighter and cleaner than the San Juan 21, though). A 4 or 5 HP 4-stroke should be plenty for the San Juan. A long shaft is good for sailboats, mainly because of the pitching action in waves that will lift a short shaft out of the water. You want to have the prop lower than you normally would for a transom mount on a powerboat, so it will stay in the water when pitching. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
12 Ft. Jon Boat - Outboard Motor Recommendations | General | |||
dead outboard? | Cruising | |||
This war is On-Topic, really, Part One, very long | General | |||
Converting I/O to Outboard with Jack Plate | General |