In article , says...

Colonel Kurtz wrote:
On 27-Aug-2010, "nom=de=plume" wrote:

I don't give a crap what you found on some web site - it's their
victory,
they need a monument, you'll probably even finance it. There will be
many
more to come.
how is it 'their victory?'

you're gonna have to explain that one...and i was there...
It's a paranoid, right-wing fantasy that says everyone who isn't white or
right-wing is bad.

I'm not stuck in the U.S. own property there or expect anything functional
from the former U.S.; you're there and need to pay attention. It's your,
your kids, and your grandkids problem. Why should 94% of the population of
Earth give a crap of what happens in your counrty?? Even you should be able
to notice the rest of the world doesn't care; your country is a dumping
ground for illiterate 3rd worlders and shoddy impiorted junk.

Speaking of which.
I'm putting new oak baseboard, shoe, and crown molding in a few rooms.
Think I already mentioned the Rigid (Chinese) orbital sander I bought.
And the Chinese knockoff of the German Fein Multimaster.
So anyway,my mitre boxes are all chewed up and my hand saws dull.
Time to get some new stuff.
Craftsman 7 1/4 sliding compound mitre saw and a Sears Evolv 3 gal
compressor with nail gun.
Think they are made in China. I usually don't bother looking anymore.
Saw was accurate right out of the box.
Better than my old 10" Rockwell radial arm.
The baseboard is too high for a mitre with the 7 1/4", but it bevels
just fine. Minor inconvenience.

The nail gun works fine so far and I've shot in about 50' of base.
Sets the nails, no marring. Using 2" 18 guage brads.
Tested same once through shoe and base and looks like I might have to
hammer set them. Maybe I wasn't holding the gun down hard enough.
Won't know until later today or tomorrow when I start putting the shoe in.
Sure beats banging a thumb and denting up wood.

The saw was $119 and the compressor/nailgun $69.
Went on the Sears website to download the saw instruction manual a week
after I bought it, and they had boosted the price to $149.
That's 10" saw range there.
Maybe for you though, that's the cost of a fence extension.
The Evolv is a typical loud, slow-pumping airless compressor.
Good for the nail gun it came with, pumping an occasional tire, and

Get a Dozuki, Japanese saw. Freaking things are magic and will put a
very nice cut on wood and thru your thumb nail and thumb. It doesn't
hurt until you see the blood. Seriously, look at the Japanese "pull"
saws, they are great for delicate work and mitering.