Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Help with Johnson 110 Trim tilt gauge
I removed the send unit after replacing the gauge and meter still not
working. I measure 6.1 volts through the entire range of motion? Is this indicating a broken send unit? Pls tell me how to test send unit. Thanks. |
#2
|
|||
|
|||
Help with Johnson 110 Trim tilt gauge
Pls tell me how to test send
unit. Hook up a ohm meter to the two sender wires, then slowly operate the sender by hand. The ohm meter gauge should move slowly and smoothly from zero to the upper limit of ther sender arm. Any skipping, sticking, jerking, etc, indicates a faulty sender. Joe (30+ Years With OMC) |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Is problem with O-Ring Seal or Valve Body | General | |||
re Wire for starter / tilt trim / etc... | General | |||
Power Trim | General | |||
Tilt / Trim switch | General | |||
Older Mercury Tilt & Trim Operation? | General |