| Home |
| Search |
| Today's Posts |
|
#3
|
|||
|
|||
Grinding/crunching noise when triming-Merc 90 O/B ??
A classic symptom on this engine. It is the dry actuating rods of the
trim/tilt cylinders pushing on the rod landing pads. Keep them lubed and your're back in business. Rob * * * "tom clark" wrote in message om... When I trim my 90HP Merc up or down I hear an intermittent snapping, grinding, crunching noise ( hard to describe). The trim pump fluid level is fine. Any ideas? Thanks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Cutlass bearing/ shaft bearing noise | General | |||
| Merc outboard leaks oil | General | |||
Threaded Mode
