About Us

Boater[_3_]

wrote:
On Thu, 01 Jan 2009 13:57:57 GMT, (Richard
Casady) wrote:

On Wed, 31 Dec 2008 17:39:22 -0500, wrote:

I was in DC and lead bullets would "chalk" up on me. If I wasn't going
to shoot them right away I only bought jacked or copper clad ammo.
I believe you, why would you lie, but the only chalked lead I have
seen came with a century old leather shot pouch. You should store the
stuff in, of all things, an ammo can. GI fifty cal cans are used to
store the other smaller types as well. The lid clamps down on a rubber
gasket. Get some silica gel packets to put in with the ammo. Are you
sure if it really matters if you shoot the corroded stuff? Badly
corroded cases could be weakened but bullets? For what its worth
either fine steel wool, or a Scotchbrite pad should easily remove that
lead carbonate.

Casady

Casady

I noticed it most with promo .22 rf like "Thunderbolts" and I shot
them up anyway. In a Norrell 10-22 it really doesn't make that much
difference if you lose a few minutes of angle down range, there will
be another round coming along about 60ms later.

I only shoot copper-coated bullets in my semi-auto handguns. I like
CCI's mini-mags in the .22 and Blazer Brass in the others. I only shoot
targets, and not formally, so this ammo is good enough for me. No
misfeeds, ftfs or other problems, either. I used Winchester white box
for a while, but thought it was "dirty."

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bullets bouncing offa water	Frogwatch[_2_]	General	32	November 18th 08 11:02 PM
Bending Resin Coated Plywood	Andrew Butchart	Boat Building	16	July 27th 06 05:48 PM
Vinyl coated stainless	Robert or Karen Swarts	Boat Building	5	October 6th 05 02:00 AM
Mercuiser Ceramic Coated Exhaust Manifold & Elbow Question?	Tommy M	General	2	June 6th 04 05:13 PM
I'm Sweating Bullets!	Tim Tisdale	General	7	July 12th 03 05:13 AM