About Us

Peter Bennett wrote in message . ..
On 20 Aug 2004 13:17:12 -0700, wrote:

Hi Chaps!
Can anyone help?.

On the back of the starter switch there are 5 connections, 2 of which
are double and 1 single. The connections are numbered 1,2 and 3.
Number 1 spade connection is the single one. Numbers 2 and 3 have
double spade end connections on them.
Am I right in assuming that the single connection( number 1)is for a
live feed from the battery?. If so, what wires go from the other
connections on the back of the switch ( numbers 2 and 3), and to
where?.
Hope I`ve made it clear enough!.
Regards
Martin

The quick and easy way to solve this problem is to use an ohmmeter or
continuity checker (even a battery and light bulb) to check for
continuity between the various terminals in each position of the
switch.

Now why didn`t I think of that!! Thankyou Peter. You are a star!.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SWITCH PANEL WIRING AND CONDUCTOR PROTECTION	Rob	Electronics	1	May 30th 04 01:44 AM
wiring from battery to starter	sprokkie	Electronics	8	February 12th 04 09:45 AM
Replaced starter (now clicking)	Matt	General	13	September 28th 03 09:18 AM
Battery Disconnect Switch (wiring)	Matt	General	1	September 20th 03 03:26 PM
alternator charging to high?	Richard Malcolm	Electronics	8	August 20th 03 10:57 AM

Menu

About Us