To make JVComm32 work with my M802, I had to connect it to the speaker
jack on the chassis, not the headphone jack. Either not enough power or
too much impedance mismatch.
"Doug Dotson" wrote:

Did you go through the Control Panel to enable input
through the mic jack on the Dell?

Doug
s/v Callista

"Charlie Johnson" wrote in message
...

I have just installed JVComm32 and have attempted to capture extremely
strong wefax transmissions...no joy. The radio is an Icom M802; the
computer is a brand new Dell laptop with Windows XP Home. As before, I
connected the output of the earphone jack to the microphone jack on the
laptop, went thru the minimal configuration process in JVComm32, and
expected to see the fax signal on the spectrum display...nothing but
noise.

On review, I realized that part of the configuration was to declare which
Com Port is connected to the sound card...since I am using the mic input,
I
selected "None".

Any ideas?