About Us

[email protected]

On Fri, 07 Nov 2008 06:19:48 +0700, Bruce in Bangkok
wrote:

On Thu, 06 Nov 2008 09:20:20 -0500, wrote:

On Thu, 06 Nov 2008 20:00:27 +0700, Bruce in Bangkok
wrote:

On Thu, 06 Nov 2008 06:36:23 -0500, wrote:

On Thu, 06 Nov 2008 11:47:42 +0700, Bruce in Bangkok
wrote:

We are talking about completely saturated balsa, not drying green
lumber to get SOME of the native moisture out. Besides, you can't get
it in the kiln while it's still sandwiched between two layers of
fiberglass and attached to a boat. If it's been wet for any length of
time, the balsa is permanently damaged anyway, and replacement is
mandated.

So, in this case, no, you can't kiln dry it.

Well, you did say you were going to put it in the oven :-)

No I didn't. I said even if you DID, it wouldn't fix the problem. :-)

Newsgroups: rec.boats.cruising
From:
Date: Wed, 05 Nov 2008 21:15:18 -0500
Local: Thurs, Nov 6 2008 9:15 am
Subject: Leaking Porthole
Forget it. It won't come even close to working. You'd have a tough
time getting the water out of that balsa baking it for weeks in a warm
oven.

Bruce-in-Bangkok
(correct Address is bpaige125atgmaildotcom)

In waht you quoted above I said "You'd" which is a contraction for
"You WOULD"

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Leaking portlights	Russell Eberhardt	Boat Building	3	September 19th 06 09:17 AM
Leaking hatches	DizzyLizzy	Cruising	4	March 15th 06 09:03 PM
porthole in a steel hull	[email protected]	Boat Building	4	January 6th 06 12:28 PM
Is this Leaking? (with photo)	Robert 7	General	2	May 27th 04 05:45 AM
leaking carb	Jerry Fahner	General	1	July 15th 03 12:47 AM

Menu

About Us