Home |
Search |
Today's Posts |
#3
![]() |
|||
|
|||
![]()
For what it's worth, I also have a yanmar single cylinder engine in my boat,
a YSE8. At idle it is also very rouogh and loud, I also get a little oil coming out fo rthe wxhasut when its cold and I have the black transom syndrome. I have had the injector tested and adjusted but still get the black moustache. Cheers Matt "Rich Hampel" wrote in message ... In article , Guillermo wrote: - The engine runs very rough at idle. If I open the engine compartment I can see the engine moving quite a bit and hear a big "tok" "tok". I was told this was normal, however still concerns me. Any ideas? Completely normal for a single cylinder diesel engine idle ... you will also find one or two 'nodes' at higher rpm where this may also happen. - Also, sometimes, after the engine first starts I can see quite a bit of oil coming out the exhaust pipe and quite a bit of smoke (dark). This goes away after a few minutes of operation. Any ideas? Engine combustion chamber isnt hot enough for complete combustion .... complete combustion will occur once combustion chamber fully comes up to operating temperature. - After running the engine for several hours, I notice that my transom has black oil stains. The boat I have (C&C 27) has the exhaust pipe coming out the transom a bit above the water line, so I guess any oil coming out the pipe stays in the whirlpool. Is this normal? Yup, At the end of the season, you might want to remove the fuel injector and take it to a specialized autonmotve shop that concentrates on rebuilding injectors (gas and diesel). The injector specialist will test the injector and see if it needs adjustment or rebuilding - oil on the transom. :-) Thanks in advance. Guillermo |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Yanmar 3GM30F Hand start problems | Boat Building | |||
Yanmar 1GM10 3 view drawing | Boat Building | |||
Problem water pump Yanmar 2GM *Redux* | Cruising |