Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
Try a search on Inland Marine sealant.
Inland and DUX both make inflatable tube sealant for slow leaks. It is air curing liquid latex. You deflate the tube, add the liquid through the valve, squish it around and reinflate. Then spend the next few hours rolling and tilting the boat to get all the interior coated. However, it will only give you another season or two of use. Once applied real professional interior patches are not possible so even the vendors recommend that it be used only as a last resort and only on the tube that is leaking. andrea wrote: My old inflateble has become porous. It's made of the neoprene, not hypalon. Have heard about some liquid that impregnates the rubber from the inside. One is supposed to sip it into the chambers. Please if anyone knows where to find it (web address). Any experience? Thx in advance. -- Glenn Ashmore I'm building a 45' cutter in strip/composite. Watch my progress (or lack there of) at: http://www.rutuonline.com Shameless Commercial Division: http://www.spade-anchor-us.com |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Boat fell off trailer | General | |||
Any boat repair will take longer and cost more than originally guessed! | General | |||
I need your advice for a new boat | Cruising | |||
Am I chasing my tail?? | Boat Building | |||
Sailor's tattoo, must be married too long, Wooden Boat Festival | General |