Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
I can use a bicycle pump or similar to evacuate my holding tank
offshore. I close both air vents, open the sea valve, and pump up the holding tank with air. I watch the joker valve for back leakage / wear indications, and now, use a 12 volt tire pump. When the pressure reaches about a pound, out goes the poo. If I did not open the sea cock, I could blow the contents out the deck pumpout fitting... This makes my list of the top 10 worst ideas I've ever heard! Pressurizing a tank can result in a cracked tank, even a metal tank (I know of at least one case in which the owner of a new stainless tank didn't have enough sense to stop pumping the toilet against what he even admitted was a LOT of backpressure till a seam exploded), blown out fittings, or an eruption through the toilet...I've seen it turn even brand new joker valves inside out. The pressure reading on your pump may only indicate about 1 lb, but it takes a lot more than that inside the tank to move anything. Sending the waste overboard is risky enough..Don't even THINK of trying to send it out the deck fitting! -- Peggie ---------- Peggie Hall Specializing in marine sanitation since 1987 Author "Get Rid of Boat Odors - A Guide To Marine Sanitation Systems and Other Sources of Aggravation and Odor" http://www.seaworthy.com/html/get_ri...oat_odors.html |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Holding Tank Location | General | |||
Holding Tank Problem | Cruising | |||
holding tank plumbing | Boat Building | |||
Holding tank cradlle | Boat Building | |||
Place in Vancouver to plumb my holding tank? | General |