| Home |
| Search |
| Today's Posts |
|
|
|
#1
posted to rec.boats.cruising,rec.boats.building
|
|||
|
|||
Removing 3 bladed prop on an Alberg 35
"Roger Long" wrote in message ... "Frogwatch" wrote Cut the prop shaft in the boat. Take out a 2" long section. Take off prop. When re-installing, use a sliding coupler to join the two pieces. This assumes you even have enough room to do this cutting. Woah! This is up there with some of the worst advice I've encountered on this newsgroup. -- Roger Long Ya, I kinda cringed when I read it. Alignment questions aside, that would have to be one strong coupler. |
|
#2
posted to rec.boats.cruising,rec.boats.building
|
|||
|
|||
|
Removing 3 bladed prop on an Alberg 35
On Tue, 14 Aug 2007 09:14:49 -0500, "KLC Lewis"
wrote: "Roger Long" wrote in message ... "Frogwatch" wrote Cut the prop shaft in the boat. Take out a 2" long section. Take off prop. When re-installing, use a sliding coupler to join the two pieces. This assumes you even have enough room to do this cutting. Woah! This is up there with some of the worst advice I've encountered on this newsgroup. -- Roger Long Ya, I kinda cringed when I read it. Alignment questions aside, that would have to be one strong coupler. Why? Isn't that just a twenty five horse motor? This is a boat, not an electrical generating station. Casady |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Removing 3 bladed prop on an Alberg 35 | Boat Building | |||
| Replacing a prop for a three bladed one. ? | General | |||
| Removing the prop shaft on a Johnson 15hp. | General | |||
| Two Bladed prop question | Boat Building | |||
| advice on removing frozen prop | General | |||
Hybrid Mode
