Home |
Search |
Today's Posts |
#3
![]() |
|||
|
|||
![]()
I have two Groco HF heads that have seen nearly 17 years of use. I looked into
other heads, but finally just did a complete pump replacement for the HFs. They have worked well, only needing a rebuild every year or two. Have you checked your discharge lines for clogging? Jerry wrote: Been using Grocco HF heads for a number of years only because, at 13.5 inches, they are the lowest height head I can find in any of the catalogs. However, I'm getting pretty tired of the poor performance, breakdowns and frequent repairs needed on these units. In my boat the head sits on a shelf that is already 8.5 inches above the floor which then slopes down even more toward the midline of the boat. Even a 1 inch taller head is uncomfortable for this crew of short legged people. Anybody know of a low rise head model that is 13 inches high or less? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
replace head on a mercruiser 350 engine | General | |||
OT--Not again! More Chinese money buying our politicians. | General | |||
Head Gasket on 50 HP 93 Evinrude | General | |||
head gasket failure, salt water in cylinders, question? | General | |||
Jabsco Head - help! | General |