| Home |
| Search |
| Today's Posts |
|
#7
posted to rec.boats.cruising
|
|||
|
|||
new tiller vendor recommendation
NE Sailboat wrote:
Luc ,,, I read this and got thinking I should get a new tiller... I've never given this one thought ... is there some reason to use lamination when fabricating a tiller? If one was to take a solid piece of wood, cut it to size, finish it up,,, a little varnish ... would that do the trick? ======= "Luc" wrote in message oups.com... West has lots of more or less "standard" tillers, but if you don't want to go there, and I wouldn't blame you, you can make it yourself. Lamination is one technique, but I've seen on other boats, and installed on an Ericson 30 a mattock handle. Now it looks like it's off the farm, which isn't too far afield, but it works, and it's solid. A tiller is no mystery good luck! Worked for Noah! Gordon |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Sheet to Tiller self steering question .. ?? | Cruising | |||
| Using a Tiller Pilot | ASA | |||
| Tiller and outboard - which one controls ? | General | |||
| Tiller control | Cruising | |||
| Tiller Pilot Linear ram. | Electronics | |||
Threaded Mode
